Frequency Response Function Module
Recording the Measurement
Figure 8 - 4.
The Automatic Parameter Setup Prompt.
• Press OK to enter the FRF module’s Taking Data mode.
Figure 8 - 5.
FRF - Taking Data Mode - Automatic Parameter Setup Hit Count.
-of-hits count
• If you have been prompted to perform automatic parameter setup, hit the object
being tested with the hammer at the opposite side from where the accelerometer is
attached. When hitting the object, try to make sure that you have one clean tap and
8 - 8 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
