Machinery Balancing Module
How to Perform a Single-Plane Procedure
Stop – If you determine that measurement conditions are stable, and to save
time you do not wish to apply the averaging process, or if the machine
conditions are in a state for which you wish to immediately capture the
measurement, or after averaging stablizes measurement results, press the
Stop function button to record the measurement. The measurement results
immediately freeze on the display. Again, the screen’s Average button changes
to a Table button, and the Stop button changes to a Start button, allowing you
to re-start the measurement, if desired.
Enter / Fire buttons always advance the job to the next balancing
run.
• Press either the Stop function button to record the measurement, as described
above.
It is recommended that you save the initial run so that you do not have to repeat it.
Then you can update the saved file with subsequent runs.
If you do not wish to save the initial run data at this time, and
instead wish to proceed with the balancing job, follow the on-
screen prompt and press an Enter / Fire key to proceed to enter
Trial Weight data.
• To save the initial run data, press the Shift (zero / up arrow) function button and
then the Save function button. The Balance - Save Setup screen displays,
allowing you to save the balancing job. Refer to Chapter 4, The Analyzer Module’s
section on How to Save, View, and Delete Analyzer Measurement Results for
details on how to save balancing setups.
After saving the balancing job, you are returned to the Initial Run screen.
You may also save the balancing job from the Balancing – Summary screen.
5 - 12 SKF Microlog - GX Series
User Manual
To Next Page
Loading...
