SKF Microlog GX Series - Page 8

The Analyzer Module 4
Overview ...................................................................... 4-1
How to Collect Standard Vibration
Measurements ........................................................ 4-3
How to Save, View, and Delete Analyzer
Measurement Results .......................................... 4-14
How to Perform Multi-Channel Measurements . 4-19
How to Measure Shaft Orbit .................................. 4-29
How to Perform a Bump Test ............................... 4-33
How to Perform Motor Current Measurements. 4-36
Machinery Balancing Module 5
Microlog Balancing Overview ................................... 5-1
Single-Plane Balancing Overview ........................... 5-1
How to Set Up the Microlog for a Single-Plane
Procedure ................................................................ 5-3
How to Perform a Single-Plane Procedure .......... 5-8
Two-Plane Balancing Procedure Overview......... 5-24
How to Set Up a 2 Plane Procedure .................... 5-26
How to Perform a Dynamic 2 Plane Procedure . 5-27
How to Perform a 1-2 Plane with Prognosis
Procedure .............................................................. 5-38
Balancing Using the Strobe light ........................... 5-47
Data Recorder Module 6
Overview ...................................................................... 6-1
How to Perform a Data Recorder Measurement . 6-2
Run Up / Coast Down Module 7
Overview ...................................................................... 7-1
How to Set Up a RUCD Measurement ................... 7-2
Recording the Measurement ................................... 7-6
Displaying Acquired Data .......................................... 7-7
Saving RUCD Data ................................................... 7-26
Frequency Response Function Module 8
Overview ...................................................................... 8-1
Additional Background Information ........................ 8-1
How to Set Up an FRF Measurement .................... 8-2
Recording the Measurement ................................... 8-7
Field Calibration ........................................................ 8-12
Saving FRF Data ....................................................... 8-13
TOC - 2 SKF Microlog - GX Series
User Manual