Stober SD6 - Page 197

ID 442426.04 197WE KEEP THINGS MOVING
Drive controller
9
Manual SD6
The value of the parameterized coordinate is generated on binary output 1
(X101.8).
The value of the parameterized coordinate is generated on binary output 2
(X101.9).
The value of the parameterized coordinate is generated on binary output 3
(X103.1).
The value of the parameterized coordinate is generated on binary output 4
(X103.2).
The value of the parameterized coordinate is generated on binary output 5
(X103.3).
The value of the parameterized coordinate is generated on binary output 6
(X103.4).
The value of the parameterized coordinate is generated on binary output 7
(X103.5).
The value of the parameterized coordinate is generated on binary output 8
(X103.6).
The value of the parameterized coordinate is generated on binary output 9
(X103.7).
The value of the parameterized coordinate is generated on binary output 10
(X103.8).
F61 BA1-source version 0
Information
Note that if encoder simulation is being used via the binary outputs,
binary output BA1 is already being used. In this case no entry is
permitted in F61.
F62 BA2-source version 0
Information
Note that if encoder simulation is being used via the binary outputs,
binary output BA2 is already being used. In this case no entry is
permitted in F62.
F63 BA3-source version 0
F64 BA4-source version 0
F65 BA5-source version 0
F66 BA6-source version 0
F67 BA7-source version 0
F68 BA8-source version 0
F69 BA9-source version 0
F70 BA10-source version 0