Stober SD6 - Commissioning

ID 442426.04 72WE KEEP THINGS MOVING
Transportation and storage
5
Manual SD6
5.1 Notes on safety
Inspect the delivery for any transport damage immediately after you receive it.
Notify any damage to the transport company immediately. Do not operate the
product if damaged.
Store the device in a dry and dust-free room if you do not install it immediately.
If the device will be stored for one year or more, make certain to read section
5.3 Storage.
5.2 Transportation
Protect the drive controller against impacts during transport. For example use
the carton in which the drive controller was delivered. Please note the figures
specified in section 4.4 Transportation, storage and operating environment.
5.3 Storage
NOTICE
Material damage!
The DC link capacitors in devices of sizes 0, 1 and 2 can lose their electrical
strength through long storage times. Considerable material damage can arise
from a reduced electrical strength of the DC link capacitors when switching on.
 Use devices in storage annually or before startup.
Perform forming for stored devices.
The graphics below show the principle network connection for 3-phase and 1-
phase devices.
Legend
L1–L3 = lines 1 to 3
N = neutral conductor
PE = protective ground
F1 = fuse
A1 = drive controllers
If annual forming is not possible, form the stored devices before commissioning
according to the wiring and voltage levels shown below.
Information
STOBER recommends connecting stored devices to the supply
voltage according to the wiring shown for one hour every year.
Please note that the drive controllers are designed exclusively for
operation in TN networks.