ID 442426.04 265WE KEEP THINGS MOVING
Communication
14
Manual SD6
14.1 Introduction
The Integrated Bus (IGB) offers the following functions:
• Direct connection
• IGB-Motionbus
• Remote maintenance
The IGB can only be set up with drive controllers of the SD6 device family.
14.2 Components
The following figure shows the components used to carry out remote
maintenance. The teleserver that establishes the connection is described in
14.4.
The illustration below shows the layout when a direct connection has been set
up to the computer.
Information
Note that IGB motion bus functionality is in preparation.
Information
Remember that an IGB network can never be accessed by remote
maintenance and direct connection (PC) at the same time.
To Next Page
Loading...
