Stober SD6 - Contact

ID 442426.04 436WE KEEP THINGS MOVING
Diagnosis
16
Manual SD6
16.65 configuration stopped
16.66 HW defective FirmwareStartErr
Triggering Level Response
The current configuration was stopped. — The configuration does not start. Alternating to the event display,
STOBER.
The power stage remains switched off, the drive is free of torque/force. A
possibly existing brake will be controlled to close. The brake chopper is
turned off.
Possible cause Test Measure Confirmable
The transfer of a new configuration by
the DriveControlSuite was
interrupted.
— Apply a configuration with the
DriveControllSuite or switch the drive
controller off and on again so that the
previous configuration can be loaded from
the Paramodule.
No
Triggering Level Response
A firmware error was detected. — The configuration does not start.
The power stage remains switched off, the drive is free of torque/force. A
possibly existing brake will be controlled to close. The brake chopper is
turned off.
Possible cause Description Measure Confirmable
The active firmware as well as the
firmware in the download memory are
faulty.
— A "normal" firmware download is not
possible. Please contact our Service
department.
No