ID 442426.04 435WE KEEP THINGS MOVING
Diagnosis
16
Manual SD6
16.63 no configuration paramodul error
16.64 no configuration start error
Triggering Level Response
An error is found by the Paramodule during start-
up.
— The configuration does not start. Alternating to the event display,
STOBER.
The power stage remains switched off, the drive is free of torque/force. A
possibly existing brake will be controlled to close. The brake chopper is
turned off.
Possible cause Test Measure Confirmable
Note the causes in section 16.50
*ParaModul ERROR:update
firmware! to 16.53 *ParaModul
ERROR: ksb write error.
— Note the measures in sections 16.50
*ParaModul ERROR:update firmware! to
16.54 *ConfigStartERROR parameters lost.
No
Triggering Level Response
There was an error when starting the
configuration.
— The configuration does not start. Alternating to the event display,
STOBER.
The power stage remains switched off, the drive is free of torque/force. A
possibly existing brake will be controlled to close. The brake chopper is
turned off.
Possible cause Test Measure Confirmable
Note the causes in section 16.54
*ConfigStartERROR parameters lost
to 16.62 *ConfigStartERROR
unknown hiding.
— Note the measures in sections 16.54
*ConfigStartERROR parameters lost to
16.61 *ConfigStartERROR unknown pre-rd.
No
To Next Page
Loading...
