ID 442426.04 281WE KEEP THINGS MOVING
Communication
14
Manual SD6
Proceed as follows:
The session ID provides additional security for remote maintenance.
If parameter A168 is set in the gateway device so that the session ID will be
prompted for remote maintenance, the service technician can only make the
connection to the drive controller by specifying the session ID.
If the blue LED does not flash even though remote maintenance is activated,
you can see the cause in parameter A178.
14.4.6 Establishment of a connection
Activate remote maintenance
1. The person responsible for the machine turns on the signal parameterized
in A167 for the drive controllers that will participate in remote
maintenance.
The drive controllers declare themselves. The LEDs on sockets X3A
and X3B flash very rapidly.
When the connection to the teleserver is set up, the blue LEDs for
sockets X3A and X3B flash regularly. The drive controller shows its
serial number in the display.
If A168 = 1:with session ID is set in the gateway device, the session
ID is displayed in addition to the serial number.
The person responsible for the machine has activated remote
maintenance. He sends a message to the service technician and tells him
the serial number of a device in the IGB network and if applicable the
session ID.
Setting up a connection
1. The service technician starts DriveControlSuite.
2. The service technician creates a new project or opens an existing project.
3. The service technician selects the module in the project and clicks the
Make connection button near the bottom of the project window.
The Make connection dialog appears.
4. In the dialog the service technician switches to the Internet connection or
LAN connection tab, depending on the specific application.
5. The service technician specifies the serial number and if applicable the
session ID.
6. If a LAN connection is being set up: The service technician clicks the LAN
teleserver settings button.
A dialog for entering the DNS designation or the IP address of the
teleserver appears.
7. If a LAN connection is being set up: The service technician enters the DNS
designation or the IP address of the teleserver and confirms the dialog
with OK.
8. If an internet connection is being set up: The service technician clicks the
Proxy settings button.
A dialog for making the necessary proxy entries appears.
9. If an internet connection is being set up: The service technician makes the
necessary entries for the proxy server and confirms the dialog with OK.
10. In the Make connection dialog the service technician clicks the OK button.
The entire IGB network is displayed in DriveControlSuite. The drive
controllers that are not shared for remote maintenance are identified by a
red prohibition sign. In the drive controllers shared for remote
maintenance you can
- read data from the drive controllers or
- initiate sending of data to the drive controllers or
- perform a live firmware update.
To Next Page
Loading...
