Stober SD6 - Page 288

ID 442426.04 288WE KEEP THINGS MOVING
Communication
14
Manual SD6
Descriptions of causes
Error
value
Description Cause no.
00
hex
Reserved –
01
hex
An error occurred in the flow control between
the teleserver and drive controller.
6
02
hex
An internal error occurred. 5
03
hex
An internal error occurred. 5
04
hex
A CRC error was detected in the HTTP
response from the teleserver.
7
05
hex
An invalid HTTP state was detected while
receiving data.
8
06
hex
An invalid HTTP state was detected while
receiving data.
8
07
hex
The teleserver has terminated remote
maintenance.
9
08
hex
The teleserver is declining the serial number. 10
09
hex
The teleserver is declining the serial number. 10
0A
hex
An internal error occurred. 5
0B
hex
An internal error occurred. 5
0C
hex
The drive controller is waiting for the connection
to DriveControlSuite.
11
0D
hex
An internal error occurred. 5
0E
hex
An error occurred in the flow control between
the teleserver and drive controller.
6
0F
hex
A CRC error was detected in the HTTP
response from the teleserver.
7
10
hex
An internal error occurred. 5
11
hex
An error occurred in the flow control between
the teleserver and drive controller.
6
12
hex
An error occurred in the flow control between
the teleserver and drive controller.
6
13
hex
An internal error occurred. 5
14
hex
An internal error occurred. 5
15
hex
An internal error occurred. 5
Cause no. Description
1 The attempt to set up the TCP/IP connection to the teleserver
failed.
Check all the network settings and the firewall.
2 The drive controller attempted to connect with the teleserver
PC. However, the specified PC actively declined the attempt
to make a connection.
Check whether the teleserver (LAN) was correctly installed
and is running. For example you can use DriveControlSuite
to check the connection with the teleserver.
3 The drive controller is unable to reach the IP address of the
teleserver with the current network settings (IP address and
subnet mask).
Check the IP addresses of the drive controller and teleserver.
4 An attempt was made to set up a TCP/IP connection to the
teleserver, but the connection is already in place.
Terminate remote maintenance properly and start remote
maintenance again.
Error
value
Description Cause no.