ID 442426.04 51WE KEEP THINGS MOVING
Technical data
4
Manual SD6
Connecting Quick DC-Link – drive controller
The DC link capacitors of exactly two drive controllers can be connected via the
SD6 output terminals. To connect the capacitors of multiple drive controllers,
you need a separate module DL6. (see also 6.5 Quick DC-Link).
Relevant design and operating instructions
Note the following factors in the planning phase and during subsequent Quick
DC-Link operation:
• the capacity of the charging circuits of the drive controllers that are
supplied with power
• the sizes of the drive controllers and
• their maximum output power.
•
Information
Note that you can only connect the 6th generation of STOBER drive
controllers.
Information
Quick DC-Link may be subject to system-specific or country-
specific standards.
To Next Page
Loading...
