Parameter list
9836 3123 01 345 (428)
If the tool does not reach its shut off point, this timer will shut it off. The
timer is activated when the tool trigger is pressed.
The value is adjustable between 0.1 and 60.0 seconds.
Activates a function that measures how many times a tightening is repeated.
It must be determined from where P151 Batch size value should be read, if
this parameter is activated.
Options:
Off: batch count functionality is not used.
Pset: use batch size of a Pset.
Fieldbus: an external source decides P151 Batch size via fieldbus.
Ethernet/serial: an external source decides P151 Batch size via Ethernet or
serial interface.
If batch count is used in a Job (that includes the specific Pset),
this parameter is recommended to be set to “Off”.
The size can be 1 - 99. To set this parameter, the P150 Batch count must be in
active mode.
Batch size defined in Job overrides batch size defined in Pset.
The tool will be locked when reaching Batch done. Batch done is reached
when the number of correct tightenings is equal to P151 Batch size.
Defines the number of possible subsequent NOK (not OK) tightenings. This
parameter is overruled by M208. To be able to set a value for P153 the
parameter J301 Job type must be set to 'Forced' or 'Free and forced'
Range: 1-10.
High speed rundown is a function for reducing the cycle time by running the
tool at high speed during rundown.
High speed rundown is a stage inserted between Soft start and Step 1, i.e. the
Soft start time and Soft start speed affects the number of degrees of the
rundown phase. This gives the possibility for fast tightening cycles even for
long bolts with a small angle that require a slow step-one speed to avoid
overshoots.
Rundown speed in percent.
High speed rundown interval.
Defines the acceleration to P161 Rundown Speed during the high speed
rundown stage. The value is adjustable between 0 and 100 percent. A low
percentage gives fast acceleration.
Disable high speed
rundown speed once
if NOK
Disable the high speed rundown function after a NOK tightening
and enable high speed rundown speed when the tightening is OK. This
function is only possible to enable if the P160 is On
Adjustable positioning limit for open end tools. Used to set torque limit for
the positioning of the tool after tightening. If set to No the internal default
value is used as limit.
To Next Page
Loading...
Need help?
General
