EasyManuals Logo
Home>Campbell>Measuring Instruments>CR1000

Campbell CR1000 User Manual

Campbell CR1000
678 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #520 background imageLoading...
Page #520 background image
Section 11. Glossary
Term. mains power
the national power grid
Term. manually initiated
Initiated by the user, usually with a CR1000KD Keyboard Display
(p. 651), as
opposed to occurring under program control.
Term. mass storage device
USB: "thumb" drive. See appendix Data Storage Devices
(p. 653).
Term. MD5 digest
16 byte checksum of the TCP/IP VTP configuration.
Term. milli
The SI prefix denoting 1/1000 of a base SI unit.
Term. Modbus
Communication protocol published by Modicon in 1979 for use in
programmable logic controllers (PLCs). See section Modbus
(p. 91).
Term. modem/terminal
Any device that has the following:
o Ability to raise the CR1000 ring line or be used with an optically isolated
interface (see the appendix CS I/O Serial Interfaces
(p. 652) ) to raise the
ring line and put the CR1000 in the telecommunication command state.
o Asynchronous serial communication port that can be configured to
communicate with the CR1000.
Term. modulo divide
A math operation. Result equals the remainder after a division.
Term. MSB
Most significant bit (the leading bit). See the appendix Endianness
(p. 643).
Term. multi-meter
An inexpensive and readily available device useful in troubleshooting data-
acquisition system faults.
Term. multiplier
A term, often a parameter in a CRBasic measurement instruction, that
designates the slope (aka, scaling factor or gain) in a linear function. For
example, when converting °C to °F, the equation is °F = °C*1.8 + 32. The
factor 1.8 is the multiplier. See Term. offset
(p. 521).
520

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Campbell CR1000 and is the answer not in the manual?

Campbell CR1000 Specifications

General IconGeneral
BrandCampbell
ModelCR1000
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals