Term. Ohm's Law
Describes the relationship of current and resistance to voltage. Voltage equals
the product of current and resistance (V = I • R).
Term. on-line data transfer
Routine transfer of data to a peripheral left on-site. Transfer is controlled by
the program entered in the datalogger.
Term. operating system
The operating system (also known as "firmware") is a set of instructions that
controls the basic functions of the CR1000 and enables the use of user written
CRBasic programs. The operating system is preloaded into the CR1000 at
the factory but can be re-loaded or upgraded by you using Device
Configuration Utility
(p. 111) software. The most recent CR1000 operating
system .obj file is available at www.campbellsci.com/downloads
(http://www.campbellsci.com/downloads).
Term. output
A loosely applied term. Denotes a) the information carrier generated by an
electronic sensor, b) the transfer of data from variable memory to final-data
memory, or c) the transfer of electric power from the CR1000 or a peripheral
to another device.
Term. output array
A string of data values output to final-data memory. Output occurs when the
data table output trigger is True.
Term. output interval
See data-output-interval
(p. 512).
Term. output-processing instructions
See data-output-processing instructions
(p. 512).
Term. output-processing memory
See data-output-processing memory
(p. 512).
Term. PakBus
A proprietary telecommunication protocol similar to IP
(p. 518) protocol
developed by Campbell Scientific to facilitate communications between
Campbell Scientific instrumentation. See PakBus — Overview
(p. 88) for more
information.
Term. PakBusGraph software
Shows the relationship of various nodes in a PakBus network and allows for
monitoring and adjustment of some registers
(p. 525) in each node. A PakBus
522
To Next Page
Loading...
Need help?
General
