Campbell CR1000 User Manual

Appendix B. Status, Settings, and Data Table Information (Status/Settings/DTI)
PakBusTCPEnabled
Settings Editor: ???
Keyboard: Settings (TCP/IP) ≈ line 39
Aliased from: ServicesEnabled()
CRBasic: variable = settings.keyword;
SetSettings()
Enables (True) or disables (False) the PakBus TCP
service.
read/write
BOOLEAN
True True or False
PakBusTCPPassword
Settings Editor: PakBus/TCP Password
Keyboard: Settings (General) ≈ line 10
CRBasic: variable = settings.keyword;
SetSettings()
When active (not blank), a log-in process using an
MD5 digest of a random number and this password
must take place successfully before PakBus
communications can proceed over an IP socket.
read/write
STRING
none
(inactive)
0 to 63
characters
PanelTemp
Station Status: Panel Temperature
Keyboard: Status Table ≈ line 15
CRBasic: variable = status.keyword
Current wiring-panel temperature. Measurement is
made in background calibration.
read only
FLOAT
°C
n/a
-40 to 85
PingEnabled
Settings Editor: Ping Enabled
Keyboard: Settings (TCP/IP) ≈ line 38
CRBasic: variable = settings.keyword;
SetSettings()
Enables (True) or disables (False) the ICMP ping
service. Replaces old ServicesEnabled().
read/write
BOOLEAN
True
True or False
PortConfig()
Keyboard: Status Table ≈ line 51
CRBasic: variable = status.keyword
Configuration of C terminals. Array elements in
numeric order of C terminals.
read only
STRING
array
Input
Input,
Output,
SDM, SDI-
12, Tx, Rx
PortStatus()
Keyboard: Status Table ≈ line 50
CRBasic: variable = status.keyword
States of C terminals configured for control.
On/high (True) or off/low (False). Array elements
in numeric order of C terminals. Updated every 500
ms.
read/write
BOOLEAN
array
False
True or False
pppDial
Settings Editor: PPP Dial
Keyboard: Settings (TCP/IP) ≈ line 28
CRBasic: variable = settings.keyword;
SetSettings()
Specifies the dial string that follows ATD (e.g., #777
for Redwing CDMA) or a list of AT commands
separated by ';' (e.g., ATV1;
AT+CGATT=0;ATD*99***1#), that are used to
initialize and dial through a modem before a PPP
connection is attempted. A blank string means that
dialing is not necessary before a PPP connection is
established. CRBasic program will recompile if
changed from NULL to not NULL, or from not
NULL to NULL.
read/write
STRING
none n/a
624

Campbell CR1000 Specifications

General

Power Requirements	9.6 to 16 VDC
Data Logger Operating System	CRBasic
Memory	4 MB
Analog Inputs	16 single-ended or 8 differential
Analog Input Resolution	13 bits
Analog Input Range	+/-2.5V
Digital I/O	8
Pulse Counters	2
Communication Ports	RS-232
Operating Temperature	-25°C to +50°C
Pulse Channels	4