Appendix B. Status, Settings, and Data Table Information (Status/Settings/DTI)
pppDialResponse
Settings Editor: PPP Dial Response
Keyboard: Settings (TCP/IP) ≈ line 29
CRBasic: variable = settings.keyword;
SetSettings()
Specifies the response expected after dialing a
modem before a PPP connection can be established.
CRBasic program will recompile if changed from
NULL to not NULL, or from not NULL to NULL.
read/write
STRING
CONNECT
n/a
pppInterface
Settings Editor: PPP Interface
Keyboard: Settings (TCP/IP) ≈ line 23
CRBasic: variable = settings.keyword;
SetSettings()
Controls which CR1000 communication port PPP
service is configured for. Warning: if this value is
set to CS I/O ME, do not attach any other devices to
the CS I/O port. A change will cause the CRBasic
program to recompile.
read/write
LONG
0 (inactive)
???
pppIPAddr
Keyboard: Settings (TCP/IP) ≈ line 24
Settings Editor: PPP IP Address
CRBasic: variable = settings.keyword;
SetSettings()
Specifies the IP address that is used for the PPP
interface if that interface is active (the PPP Port /
PPP Interface setting needs to be set to something
other than Inactive). Syntax is nnn.nnn.nnn.nnn.
A value of 0.0.0.0 or an empty string will indicate
that DHCP must be used to resolve this address as
well as the subnet mask.
read/write
STRING
0.0.0.0
0–255.0–
255.0–255.0–
255
pppIPMask
Settings Editor: ???
Keyboard: Status Table ≈ line 25
CRBasic: variable = settings.keyword;
SetSettings()
read/write
STRING
none
0–255.0–
255.0–255.0–
255
pppPassword
Settings Editor: PPP tab: Password
Keyboard: Status Table ≈ line 27
CRBasic: variable = settings.keyword;
SetSettings()
Specifies the password that is used to log in to the
PPP server when the PPP interface setting is set to
one of the client selections. Also specifies the
password that must be provided by the PPP client
when the PPP interface setting is set to one of the
server selections.
read/write
STRING
none
0 to 63
characters
pppUsername
Settings Editor: PPP User Name
Keyboard: Settings (TCP/IP) ≈ line 26
CRBasic: variable = settings.keyword;
SetSettings()
Specifies the user name that is used to log in to the
PPP server.
read/write
STRING
none
0 to 63
characters
ProcessTime
Keyboard: Status Table ≈ line 40
CRBasic: variable = status.keyword
Processing time of the last scan. Time is measured
from the end of the EndScan instruction (after the
measurement event is set) to the beginning of the
EndScan (before the wait for the measurement event
begins) for the subsequent scan. Calculated on-the-
fly. See MeasureTime (p. 621), MaxProcTime (p.
read only
LONG
μs
0 n/a
625
To Next Page
Loading...
Need help?
General
