SV-ADAHRS-200 Module Installation and Configuration
SkyView HDX System Installation Manual - Revision E 7-3
Mounting requirements for the SV-ADAHRS-200:
• Must be mounted within one (1) degree of parallel to all three (3) aircraft axes,
• The pneumatic fittings must face toward the front of the aircraft,
• The mounting tabs must be towards the bottom of the aircraft, with the label
towards the top of the aircraft.
Figure 39 shows the correct orientation of the ADAHRS as it would appear if you were
above the aircraft, looking down at it. The module will not operate properly if it is rotated,
or inverted, or in any other orientation.
To Next Page
Loading...
