Dynon SkyView HDX - How to Export System Settings

Display Operation
SkyView HDX System Installation Manual - Revision E 21-17
Figure 126: Some SkyView Network devices not online, cannot update
If you see a screen similar to the one (1) in Figure 126 above, power on or reconnect all
SkyView Network devices. This error is typically caused by Autopilot servos or the SV-
COM-X83 radio not being powered on.
5. Update the Software on the unit by pressing UPDATE or press CANCEL to return
to the SYSTEM SOFTWARE Menu.
6. To aid in troubleshooting, during the Software update process, your SkyView
system’s previous configuration files are automatically written to the USB flash
drive in a subdirectory (folder) called “settings_archive”:
TAILNUMBER_SNXXXX_SOFTWAREVERSION_SENSORS_SW_UPGRADE.sf
g
TAILNUMBER_SNXXXX_SOFTWAREVERSION_SW_UPGRADE.sfg
21.7.2 How to Export System Settings
This operation creates a set of files on the USB flash drive that contain display
settings, equipment settings, and important calibration information. All the
filenames contain the tail number and the Software version.
1. Insert the USB flash drive into one (1) of the display’s USB sockets.
2. Go to the Export Settings Wizard (SETUP MENU > SYSTEM SOFTWARE >
EXPORT SETTINGS…).
3. Create a file name for the settings file.