EasyManua.ls Logo

Dynon SkyView HDX - How to Enter Setup Menus; In Flight Setup Menu

Dynon SkyView HDX
374 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Display Operation
SkyView HDX System Installation Manual - Revision E 21-7
3. Confirm the highlighted function by pushing the knob (pushbutton),
OR
Wait approximately seven (7) seconds; the Function Menu will close, and the
highlighted function will be selected.
If the Map Page is onscreen, the joystick or knob closest to the Moving Map is labeled
(RNG) and is used to adjust the map’s range. It cannot be assigned a different function.
If the Knob Function menu does not display all of the Bugs that you wish to
select from, it means some of the Bugs are disabled. To enable the desired
Bugs, go to the PFD menu and select BUGS. In the BUGS menu, enable the
desired bugs. Then the desired Bugs will be selectable in Knob menu.
21.5.6 How to Enter the Setup Menus
There are two (2) setup menus: The Setup Menu and the In-Flight Setup Menu.
Simultaneously pressing and holding buttons 7 and 8 will open one (1) of these menus.
If the airspeed is zero, the Setup Menu will open. If the airspeed is greater than zero (0),
the In-Flight Setup Menu will open.
You may also access the Setup Menu from the In-Flight Setup Menu by using the ENTER
FULL SCREEN SETUP MENU option.
21.5.7 How to Adjust Time Zone Offset
First, configure the Top Bar to display time in SETUP MENU > LOCAL DISPLAY
SETUP > TOP BAR SETUP > TIME: ZULU | LOCAL.
Then, adjust your preferred offset from the time currently displayed on the Top Bar
SETUP MENU > SYSTEM SETUP > TIME.
21.5.8 How to Configure Units of Measure
Displayed units can be configured for altitude, distance, speed, temperature, barometer,
pressure, and volume. Displayed units are configured on the Measurement Units Page
(SETUP MENU > SYSTEM SETUP > MEASUREMENT UNITS).
21.6 In Flight Setup Menu
This menu contains links that may be useful during flight:
ADAHRS SOURCE SELECTION.
FLIGHT ANGLE PITCH ADJUST.
COMPASS CALIBRATION.
AOA CALIBRATION.
AUTOPILOT SETUP.
ENTER FULL SCREEN SETUP MENU.
Note that this menu occupies only half of the screen and that all the links in the In-Flight
Setup Menu are accessible via the SETUP MENU.

Table of Contents

Other manuals for Dynon SkyView HDX

Related product manuals