EasyManua.ls Logo

Dynon SkyView HDX - PFD SETUP Menu

Dynon SkyView HDX
374 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Display Operation
21-12 SkyView HDX System Installation Manual - Revision E
GPS FIX STATUS Shows fix quality information for the GPS source that is
being used as the active position source for SkyView’s moving map and
synthetic vision. Note that this does not show information about other GPS
sources that may be available for HSI and backup position use.
BATTERY BACKUP (SV-BAT-320) STATUS Shows the status of automated
tests of the SV-BAT-320.
LICENSE Shows the status of Software products that can be purchased and
licensed to add features to SkyView. This page is also the place where license
codes can be redeemed to activate features on your SkyView System.
VIDEO INPUT SETUP If a SkyView Video Input Adapter (USB) is connected
to this display, options such as video input format and orientation can be
selected. If a SkyView Video Input Adapter (USB) is not installed, this selection
is grayed out and not accessible.
21.6.6 PFD SETUP Menu
This menu contains menus and pages related to Primary Flight Display page and data
source (ADAHRS module).
ADAHRS SOURCE SELECTIONThis page has a list of all configured
SkyView ADAHRS modules and their respective status. The ADAHRS module
used as the PFD’s source of data can be selected.
FLIGHT ANGLE PITCH ADJUST This page allows you to adjust the
displayed pitch of the waterline symbol (aircraft reference on the attitude
indicator) to compensate for the aircraft’s attitude in level flight. That attitude
can change depending on aircraft loading. This setting is not intended to
compensate for an ADAHRS module that is not installed correctly.
AIRSPEED LIMITATIONS Enter this menu to configure the V-speeds and
specify optimal flight parameters, such as the best angle of climb speed, the
best rate of climb speed, and the optimum maneuvering speed.
VERTICAL SPEED SCALE Enter this page to configure the vertical speed
tape's scale.
G METER Enter this page to configure G values that will cause the G Meter
to be automatically displayed when exceeded; to set the yellow/red cautionary
color ranges of the G meter; and whether or not the max/min recorded G’s are
reset at each SkyView boot-up.
FLIGHT PATH MARKER Enter this page to enable/disable display of the flight
path marker.
EXTREME PITCH WARNING Enter this page to enable/disable display of the
extreme pitch warning indicators.
ANGLE OF ATTACK Enter this page to enable/disable display of the Angle
of Attack indicator.

Table of Contents

Other manuals for Dynon SkyView HDX

Related product manuals