Appendix A: Maintenance and Troubleshooting
23-8 SkyView HDX System Installation Manual - Revision E
6. Assuming the Autopilot was previously set up and working correctly, you only need
to recalibrate the servos by going to SETUP MENU > HARDWARE CALIBRATION
> AP SERVO CALIBRATION > CALIBRATION and following the on-screen
instructions.
23.7.3 All other SkyView Network Components
1. Reinstall the SkyView Network component in the aircraft.
2. Reconnect all harnesses and connections as originally installed.
3. Power up the entire SkyView System (all displays, modules, servos, etc.).
4. From any display in the aircraft, reconfigure SkyView Network under SETUP
MENU > SYSTEM SETUP > SKYVIEW NETWORK SETUP > CONFIGURE.
5. No further action should be required.
23.8 Operational Status
SkyView displays give users access to vital operational information in the Display
Hardware Information Page (SETUP MENU > LOCAL DISPLAY SETUP > DISPLAY
HARDWARE INFORMATION). Note that the information in this menu may be useful
during troubleshooting. The information here cannot be edited on this screen; however,
some parameters are editable by the user on other screens.
This menu contains the following information:
• Display serial number.
• Software version.
• Display input voltage.
• SV-BAT-320 charge state.
• Operational state of the internal battery management circuitry.
• Operational state of the internal voltage rails.
• Screen brightness level.
• Local light sensor output.
• External light sensor output.
• Brightness level output.
• Contact input status.
• Serial port status and current baud rate.
• Button and joystick states.
• Operational hours.
23.8.1 Display Serial Number
The serial number of the display is noted here as SERIAL NUMBER: XXXXXX.
To Next Page
Loading...
