Dynon SkyView HDX - Maintenance Log Setup

SkyView HDX Display Installation and Configuration
4-32 SkyView HDX System Installation Manual - Revision E
After setup is complete, Weight and Balance is accessed from the MENU > WEIGHT BAL
icon (SkyView HDX). For instructions on how to use the Weight and Balance feature, see
the SkyView HDX Pilot’s User Guide.
For Weight and Balance calculations to be displayed, several settings must be entered
for your specific aircraft:
• SETUP MENU > AIRCRAFT INFORMATION > WEIGHT & BALANCE
o > MAX GROSS WEIGHT
o > EMPTY WEIGHT
o > EMPTY ARM
o > EMPTY MOMENT
o > STATIONS
▪ At least one (1) Station is required. Up to nine (9) Stations can be
defined.
▪ Typically, Stations would be defined for Fuel, Pilot, Co-pilot, and
Baggage
▪ Each Station entry consists of:
▪ > NAME
▪ > MAX Weight
▪ > ARM
▪ > ENTER AS FUEL (Y/N)
o > CG LIMITS
▪ A minimum of two (2) CG Limits is required. Typically, enter a CG limit
for the forward maximum CG points and a CG limit for the aft maximum
CG point. More complicated limits for different weights (such as with a
C172) can be accommodated.
▪ > WEIGHT
▪ > ARM
4.4.10 Maintenance Log Setup
SkyView HDX can provide up to 10 maintenance reminders based on date, elapsed tach
time, or elapsed Hobbs Time. A maintenance reminder can also be displayed with no time
basis (display text only).
After setup is complete, the Maintenance Log is accessed from the MENU > MAINT LOG
icon. For instructions on how to use the Maintenance Log feature, see the SkyView HDX
Pilot’s User Guide.
Each item in the maintenance log requires entry of the time basis (or NONE) to determine
whether the item is not yet due, due, or overdue.