SV-KNOB-PANEL Panel Installation
SkyView HDX System Installation Manual - Revision E 5-3
5.2 Electrical Installation
SkyView Network
The SV-KNOB-PANEL has two (2) SkyView Network connections (D9 connectors). Both
connectors are electrically identical and are internally connected. Thus, the SV-KNOB-
PANEL can be installed in the SkyView Network as a “pass-through” device, or “daisy
chained” from one (1) SkyView Network device, through the SV-KNOB-PANEL, to the
next SkyView Network device. The SV-NET-1.5CC is an 18-inch (45.72 cm) SkyView
Network cable that is ideal for such situations. The SV-AP-PANEL receives power (for
operation of the buttons) from SkyView Network. Backlighting of the SV-KNOB-PANEL is
controlled by the SkyView display(s).
5.2.1 Network Setup
As with all other SkyView Network devices, the SV-KNOB-PANEL must be configured
into the SkyView Network:
• Go to SETUP MENU > SYSTEM SETUP > SKYVIEW NETWORK SETUP >
CONFIGURE > (right click) > DETECT (button).
• The SV-KNOB-PANEL(s) will be listed.
• FINISH (button) > EXIT (button).
5.3 Post Installation Checks
• Verify the knobs work as expected.
• Verify dim commands from SkyView display dim the backlighting of the SV-
KNOB-PANEL.
To Next Page
Loading...
