SV-OAT-340 OAT Sensor Installation
SkyView HDX System Installation Manual - Revision E 9-1
9 SV-OAT-340 OAT Sensor Installation
The SV-OAT -340 Sesnor measures the Outside Air Temperature, and provides this data
to SkyView by connecting to either the SV-ADAHRS-200 ADAHRS module or the SV-
MAG-320 Remote Magnetometer.
9.1 Mechanical Installation
The SV-OAT-340 is an outside air temperature sensor. In order for it work properly, it
must be able to measure air temperature accurately. Avoid exposing the sensor to
sources of heat that would interfere with outside air temperature readings such as:
• Direct sunlight.
• Engine heat and exhaust.
• Aircraft interior (back side of sensor).
• Heated air from the cabin exiting from an open window or cabin air exhaust port.
The installation area should have space for a nut and wires on the back side of the sensor.
It is acceptable to extend or reduce the wire length if necessary. Reduce the wire length
by cutting out the desired length from the middle of the wires and splicing together the
remaining ends.
To Next Page
Loading...
