Dynon SkyView HDX - Displaying Your Checklist on Your Skyview Display

Appendix H: Checklists
SkyView HDX System Installation Manual - Revision E 30-9
CHKLST0.TITLE, PRE-FLIGHT
CHKLST0.LINE1,
CHKLST0.LINE2, BUILD YOUR CHECKLIST HERE
is correct.
CHKLST0.TITLE, PRE-FLIGHT
CHKLST0.LINE1,
CHKLST1.LINE2, BUILD YOUR CHECKLIST HERE
is not correct (Checklist numbers do not match).
Also, check that each Checklist item) has a correct, sequential number. Example:
CHKLST0.TITLE, PRE-FLIGHT
CHKLST0.LINE1
CHKLST0.LINE2, BUILD YOUR CHECKLIST HERE
is correct.
CHKLST0.TITLE, PRE-FLIGHT
CHKLST0.LINE1,
CHKLST0.LINE1, BUILD YOUR CHECKLIST HERE
is not correct (there are two (2) CHKLST0.LINE1 lines; the second should be
CHKLST0.LINE2).
If you cannot get your Checklist file to load (“FILE HAS ERROR” screen), you can isolate
where the problem is in your Checklist file by “commenting out” individual lines, or entire
sections, by prepending the line with a # and a space character. Example:
# CHKLST0.TITLE, PRE-FLIGHT
A future version of SkyView Software will enhance the error message shown in Figure
157 above to display the line number where an error is encountered.
Lines that begin with # will not be processed / checked when the Checklist file is loaded.
Admittedly this will be tedious if your SkyView display is in your aircraft and your computer
is at home, so this is best done using a laptop computer in the aircraft, so you can edit,
export, and test rapidly on your SkyView display.
Once a Checklist is loaded, there is no way to delete the current Checklist. The closest
thing to a “delete Checklists” function is to load an empty file (no text in it) with a filename
such as blankchecklist.txt. This will have the effect of displaying a blank page when the
CHECKLIST button is pressed.
30.6 Displaying Your Checklist on your SkyView Display
Until a Checklist file is loaded into your SkyView system, the CHECKLIST
button will not appear in the TOOLS menu. A default / example Checklist is
not installed in new SkyView displays, nor is a default / example Checklist
automatically installed into a SkyView display as part of updating your
SkyView system to Software v14.0.
To access your Checklist on a SkyView display, from the main menu, go to the TOOLS
menu and push the CHECKLIST button. The Checklist will continue to be displayed until