Display Operation
SkyView HDX System Installation Manual - Revision E 21-9
Figure 125: System Event Display
If no critical system events have occurred on your SkyView display, “SYSTEM EVENT”
will not appear as a menu item.
If a SYSTEM EVENT does appear, it will contain instructions on what to do next.
21.6.3 SYSTEM SOFTWARE Menu
You must have a USB flash drive that is recognizable by the display in one (1)
of the USB slots to open this menu. All of the functions under this menu either
write to or read from the flash drive.
Detailed instructions for all of the menus listed below are included in the
Software Updates and File Operations Section of this manual.
The SYSTEM SOFTWARE Menu contains links to the following wizards:
• UPGRADE SYSTEM SOFTWARE. – Use this wizard to update Software on
your SkyView system.
• LOAD FILES – Use this wizard to load files such as settings or configuration
files or delete files from the USB flash drive.
• EXPORT SETTINGS – Use this wizard to export the settings on your SkyView
system to a USB flash drive. Note that (as of V6.0) calibration settings are not
exported, including servo calibrations, fuel tank calibrations, and compass
calibrations.
To Next Page
Loading...
