Display Operation
SkyView HDX System Installation Manual - Revision E 21-5
Table 47: Menu Navigation Summary
Simultaneously press and hold buttons 7 and 8
(if airspeed is greater than zero (0), you will enter the
In Flight Setup Menu)
Scroll through different menus
SkyView HDX: Push the knob (pushbutton)
Press BACK (saves settings)
OR
Press CANCEL (does not save settings)
Save settings and return to Main
Menu
21.5 Display Operation Procedures
This subsection covers basic operation procedures for displays. Detailed instructions for
various menus and individual menu items are described later in this manual.
21.5.1 How to Turn the System On or Off
Table 48: Toggling SkyView System Power
Toggle SkyView System Power
Toggle primary power state
OR
Toggle display power by pressing and holding button 1
Toggle primary power state
OR
Toggle all displays off or on by pressing and holding button 1
on each display.
21.5.2 Loss of Aircraft Power with SV-BAT-320 Connected
If external power is lost to a display that is connected to a SV-BAT-320 Backup Battery,
it will either stay on for an additional 30 seconds or stay on indefinitely depending on
whether or not the aircraft is in flight. This feature minimizes SV-BAT-320 discharge when
on the ground and the master/external power is shut off normally while simultaneously
reducing pilot workload during an actual in-flight power loss.
If the aircraft is not in flight, SkyView displays the message “POWERING DOWN IN xx
SECONDS” while counting down from 30 seconds. During this countdown, the menu
displays the buttons STAY ON and PWR OFF at the bottom of the screen. Press PWR
OFF to turn off the SkyView display immediately. Press STAY ON to keep the SkyView
display on via the connected SV-BAT-320. If STAY ON is pressed, the display will
To Next Page
Loading...
