SV-ADSB-472 ADS-B IN Receiver Installation and Configuration
SkyView HDX System Installation Manual - Revision E 14-3
The following guidelines should be followed, remembering to allow adequate space for
installation of cables and connectors:
• Select a position in the aircraft that is not too close to any high external heat
source. (The SV-ADSB-472 is not a significant heat source itself and does not
need to be kept away from other devices for this reason).
• Avoid sharp bends and placing the cables too near to the aircraft control cables.
• Avoid locations that are subject to severe vibration.
• Avoid locations that are subject to extreme humidity.
• Leave ample working room for electrical connections.
14.1.1 Installation Instructions
The SV-ADSB-472 is designed to be mounted in any convenient location in the cockpit,
the cabin, or an avionics bay.
The following installation procedure should be followed, remembering to allow adequate
space for installation of cables and connectors:
• Select a position in the aircraft that is not too close to any high external heat
source. (The SV-ADSB-472 is not a significant heat source itself and does not
need to be kept away from other devices for this reason).
• Avoid sharp bends and placing the cables too near to the aircraft control cables.
• Secure the SV-ADSB-472 to the aircraft using its four (4) mounting holes. The
device should be mounted to a flat surface. The mounting tabs on each side of
the module have holes sized for #8-32 fasteners. It is up to the installer to
decide how the module will be secured to the aircraft.
Additional items you will require, but which are not in the SV-ADSB-472 package, include:
• SV-HARNESS-ADSB (or equivalent harness assembled by installer)
• Antenna and fixing hardware. Antenna selection suggestions are available in
the following section.
• Antenna cable and BNC Male connector. You need to supply and fabricate all
required antenna cables (or provided as part of your ADS-B antenna).
Guidance on cable types is given below.
• Mounting hardware: To secure the SV-ADSB-472 to the aircraft.
To Next Page
Loading...
