Display Operation
21-10 SkyView HDX System Installation Manual - Revision E
• EXPORT USER DATA LOGS – Use this wizard to export user data logs in
human-readable CSV format. See Appendix F: User Data Logs for further
information about user data logs.
• EXPORT USER WAYPOINTS – Use this wizard to export all of the User
Waypoints that are currently stored in your SkyView system.
• EXPORT DYNON DIAGNOSTIC FILE – This specialized data log can only be
interpreted by Dynon Avionics personnel; there is no data in it that can be
interpreted by SkyView pilots. Dynon Avionics Technical Support may request
this log during troubleshooting, especially for issues related to AP performance.
Note that this log is very big – over 500 MB – and takes minutes to save to a
USB flash drive. Unless directed to export this log by Dynon Avionics, there is
no reason to do so.
If you have more than one (1) SkyView display in your system, you may be
requested to save the Dynon Avionics Diagnostic File from each of your
SkyView displays, as each display can sometimes contain different diagnostic
data. If you save the Dynon Avionics Diagnostic File from multiple displays onto
the same USB flash drive, use the 33-character name field to distinguish the
two (2) files, such as naming one file “LEFT” and the other file “RIGHT.”
21.6.4 SYSTEM SETUP Menu
This menu contains menus and pages related to the entire SkyView system. When a
setting is changed in one (1) of these menus, it is synchronized to other SkyView displays.
• SKYVIEW NETWORK SETUP – Enter this menu to configure your SkyView
network or to check on network status (i.e., display important SkyView module
information).
• WI-FI SETUP – Enter this menu to configure the Wi-Fi system – password, etc.
• SERIAL PORT SETUP – Enter this menu to configure the five (5) general
purpose serial ports on all displays.
• AUDIO SETUP – Enter this menu to configure the options and volume for
SkyView’s audio output capability.
AIRCRAFT INFORMATION – Enter this page to record important information
regarding your aircraft. Specifically, enter the tail number of your aircraft – it is
used to create unique SkyView configuration files. It is also used for other
purposes. Note that for US planes, the leading N is a required part of the TAIL
NUMBER. The TAIL NUMBER should not include dashes (-) or spaces.
Examples:
Correct: N12AB
Incorrect: N-42SV
or N 42SV
• MEASUREMENT UNITS – Enter this page to configure displayed units (e.g.,
feet or meters).
To Next Page
Loading...
