SV-XPNDR-261 Transponder Installation and Configuration
SkyView HDX System Installation Manual - Revision E 12-23
will display the pressure altitude being transmitted to the transponder in the normal
SkyView altitude display on the right side of the PFD page.
However, note that there is a single point altitude adjustment, located in SETUP MENU
> HARDWARE CALIBRATION > ADAHRS CALIBRATION > ALTITUDE OFFSET that
adjusts SkyView’s barometric altimeter. This adjustment affects both the displayed
altitude and the encoded altitude that is sent to other devices.
12.5 SV-XPNDR-261 Software Updates
If your SkyView system has more than one (1) SkyView display, before you
commence with the SV-XPNDR-261 Software update, it is recommended to
power off all but one (1) SkyView display. Doing so will reduce the power
drain on your aircraft electrical system during the SV-XPNDR-261 Software
update, and minimize the chances of any interruptions to the update process
while it is underway.
You can power off an individual display by pushing and holding Button 1 on
the display to be powered off.
To Next Page
Loading...
