Dynon SkyView HDX - System Overview; Required Equipment; Optional Equipment

System Overview
SkyView HDX System Installation Manual - Revision E 2-1
2 System Overview
2.1 Required Equipment
The SkyView HDX System STC SA02594SE requires that the following equipment be
installed:
• HDX1100 or HDX800
• EFIS-D10A Standby Display
• SV-ADAHRS-200 ADAHRS
• SV-OAT-340 Outside Air Temperature sensor
• SV-GPS-2020 GPS Antenna/Reciever
• SV-MAG-236 Remote Magnetometer
• SV-BAT-320 Backup Battery
2.2 Optional Equipment
The following optional equipment may also be installed if available for your airplane:
NOTE: Not all options may be available for your aircraft. Check SA02594SE_AML for the
system options available for your aircraft’s make and model.
• HDX1100 or HDX800 Secondary Display(s) (maximum of two Secondary displays)
• SV-BAT-320 Backup Battery (one required for each secondary display)
• SV-XPNDR-261 Transponder Mode-S, Class 1 (ADS-B OUT)
• SV-ADSB-472 ADS-B Receiver (Traffic and Weather)
• SV-EMS-220 Engine Monitoring System (and related sensors)
• SV-COM-X83 COM Radio.
• SV-ARINC-429 ARINC 429 Interface Module
• SV-KNOB-Panel Knob Control PanelAutopilot System:
Roll and pitch servos are required autopilot equipment.The following are optional
autopilot equipment:
▪ Yaw Damper Servo
▪ SV-AP-PANEL Autopilot Control Panel
▪ SV-BUTTON-APDISC Autopilot Disconect Button
▪ SV-BUTTON-LEVEL Autopilot Level Button