Dynon SkyView HDX - Display Software Version; Display Input Voltage; BAT-320 Charge State; Operational State of the Internal Battery Management Circuitry

Appendix A: Maintenance and Troubleshooting
SkyView HDX System Installation Manual - Revision E 23-9
23.8.2 Display Software Version
The Software version of the display is noted here as SOFTWARE VERSION:
X.X.XX.XXX.
23.8.3 Display Input Voltage
The display's input voltage is list here as VOLTAGE: XX.XXV.
23.8.4 SV-BAT-320 Charge State
If there is an SV-BAT-320 connected to the display, its voltage level is shown here as
BATTERY STATUS: XX.XXV. The battery is fully charged at 12.25V. Charging a
completely discharged battery may take up to 4 hours. To conserve your aircraft battery,
the SV-BAT-320 is only charged with SkyView detects your alternator/generator to be
online.
23.8.5 Operational State of the Internal Battery Management Circuitry
The operational state of the display's internal battery management circuitry is listed here.
If there is an SV-BAT-320 connected to the display, you will see one (1) of the following
states:
• CHARGING: SkyView system voltage is above 12.25V. SkyView is running on
master power and is charging the SV-BAT-320.
• DISCHARGING: SkyView system voltage is below 10V. SkyView runs on the
SV-BAT-320. The SV-BAT-320 discharges.
• CHARGED: SkyView system voltage is above 12.25V, and the SV-BAT-320 is
fully charged.
• STANDBY: SkyView system voltage is above 10V, but below 12.25V: SkyView
runs on master power but does not charge the SV-BAT-320. To conserve your
aircraft battery, the SV-BAT-320 is only charged with SkyView detects your
alternator/generator to be online.
• NO BATTERY: No SV-BAT-320 is connected.
23.8.6 Operational State of the Internal Voltages
There are several important voltages in the display. You will find their statuses here. If
they are all operating at specified levels, then you will see OK. If any voltage is operating
out of specification, you will see X.XV FAIL for that voltage.
23.8.7 Screen Brightness Level
The screen's brightness level is shown here as a percent. For example, 100.0 means
100% and 50.0 means 50%.
23.8.8 Local Light Sensor Output
Each SkyView display has an integrated light sensor on the front bezel and its output is
shown here.