System Overview
2-22 SkyView HDX System Installation Manual - Revision E
14. Common issues for setting up SV-XPNDR-261:
a. Ensure that a valid tail number has been set (see above).
b. Ensure that a valid HEX CODE has been set: SETUP > TRANSPONDER
SETUP > TRANSPONDER HEX CODE. A caution message – XPNDR HEX
CODE NOT SET will appear if a transponder is configured in SkyView, but the
HEX CODE is not set to a valid number.
c. Traffic will not be displayed unless you are in an area covered by an TIS radar
site (US only).
15. Common issues for setting up Dynon Avionics Autopilot:
a. Servos must be powered ON.
b. Servos must be recognized on the SkyView Network (above).
c. AIRSPEED LIMITATIONS must be set (at least one (1) must be actively
adjusted from the defaults) before the Autopilot can be configured: SETUP >
PFD SETUP > AIRSPEED.
d. AP SERVO CALIBRATION must be performed: SETUP > HARDWARE
CALIBRATION > AP SERVO CALIBRATION > CALIBRATION.
e. After the AP SERVO CALIBRATION has successfully completed, the AP status
will be displayed on the SkyView display top bar.
To Next Page
Loading...
