Dynon SkyView HDX - Page 56

SkyView HDX Display Installation and Configuration
4-2 SkyView HDX System Installation Manual - Revision E
Choose a panel
Location based on
location
Requirements
section
Prepare the
Panel (cut
Opening and drill
Holes)
Install SkyView
Display harness
(SV-HARNESS-D37)
Connect power
and ground wires
With Breaker on
panel
Test display
Power (Turn on or
Use multimeter)
Connect other
SkyView modules
(e.g., ADAHARS and
EMS)
Reference
other chapters
In this guide
Connect external
Serial devices
(e.g., transponder
And GPS)
Mount display in
panel
Check for
Firmware
update
Update terrain
Database?
(Outside North
America)
Update
Aviation
Database?
Download and
Install firmware
Download and
Install terrain
database
Download and
Install aviation
database
Configure display
Settings and
Skyview network
No
New
firmware
No
No
Yes Yes
New
firmware
Figure 24: Suggested SkyView Display Installation Procedure