SkyView HDX Display Installation and Configuration
SkyView HDX System Installation Manual - Revision E 4-23
o This configuration will automatically set the SERIAL IN FUNCTION, SERIAL
IN/OUT BAUD RATE, and SERIAL OUT DEVICE.
Set the radio status to be displayed on the top bar: SETUP > SYSTEM SETUP >
DISPLAYED COM > (device you chose above) (PORT x) and SETUP MENU > SYSTEM
SETUP > DISPLAY COM IN TOP BAR: YES
4.3.9.16 Emergency Location Transmitter (ELT)
SkyView can provide a GPS data stream to ELTs that accept GPS data in NMEA format.
• Wire a serial transmit (TX) line from one (1) display to the receive (RX) line on
the ELT. If you have more than one (1) SkyView display, make the same
connection to all SkyView displays.
• Ensure there is a shared ground between the SkyView display and the ELT. If
you have more than one (1) SkyView display, make the same connection to all
SkyView displays.
• Configure the SkyView display serial port:
SETUP MENU > SYSTEM SETUP > SERIAL PORT SETUP > SERIAL
PORT x SETUP.
SERIAL IN DEVICE: (don’t care, does not affect ELT).
SERIAL IN/OUT BAUD RATE: (set to match speed of ELT; typically 4800 or
9600).
• SERIAL OUT DEVICE: NMEA OUT (BASIC).
4.3.9.17 Dynon Avionics ADAHRS / EMS / SYSTEM / NMEA (GPS) Data Outputs
To output real-time data to an external serial device, such as a serial data logger or other
device that accepts NMEA or Dynon Avionics formats:
• Wire a serial transmit line from one (1) display to the receive line on the
external serial device. If you have more than one (1) SkyView display, make
the same connection to all SkyView displays.
• Ensure there is a shared ground between the SkyView display and the
external serial device. If you have more than one (1) SkyView display, make
the same connection to all SkyView displays.
• Configure the serial port on the display appropriately under SETUP MENU >
SYSTEM SETUP > SERIAL PORT SETUP, SERIAL PORT x SETUP >
selecting the desired output data format.
4.3.9.18 TIS Format Traffic Output
SkyView can be configured to output TIS format traffic information for external display on
other avionics that can receive traffic in TIS format. When this option is selected, only the
actual TIS traffic from a SV-XPNDR-261 is included in this serial data stream. This stream
does not include ADS-B, FLARM, Zaon, or other traffic sources that may be available to
SkyView.
To Next Page
Loading...
