62
SECTION 5 - REMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
Figure 183
225037
Fit the gear (2) and tighten the nut (1) to the torque shown
in the table.
Ref.
No. Description
Tightening
torques
(1) 1 Nut M24 X 1.5 275 ± 25 Nm
Remove the tool 99360612 for engine flywheel locking.
NOTE Carefully clean the seating of the filter and the
cover.
Figure 184
221043
Fit the new blow-by filtering element (1) into its seat and
tighten the screws (2) to the torque indicated in the table.
Ref.
No. Description
Tightening
torques
(2) 3
ScrewsM6X1X40
Step 1 5Nm
Step 2 15 ± 1.5 Nm
NOTE Apply Loctite 243 to the screws (2).
Position the blow-by cover (4) and tighten the screws (3) to
thetorqueindicatedinthetable.
Ref.
No. Description
Tightening
torques
(3) 6 Screws M6 X 1 X 25 7±1Nm
Figure 185
221126
Tighten the fastening screws following the sequence indicated
in the figure.
Figure 186
227758
Assemble the thermostat, the thermostat box (3), with
relative gaskets and tighten screws (1, 2) to the torque shown
in the table.
Ref.
No. Description
Tightening
torques
(1) 5 M8 X 1.25 X 100 30 ± 3 Nm
(2) 2 M8 X 1.25 X 50 30 ± 3 Nm
Connect to the thermostat (3) the coolant supply pipe to the
radiator assembly and tighten the clamps (4).
Refit the protection grilles as described in the procedure
”PROTECTION GRILL REMOVAL - REFITTING”.
To Next Page
Loading...
