12
SECTION 5 - REMOVAL - REFITTING OF THE MAIN ENGINE COMPONENTS
CURSOR SERIES
Base - 03/2015 Print P4D32C006 E
ELECTROMAGNETIC COUPLING PULLEY
REMOVAL-REFITTING
Removal
Remove the protection grilles as described in the procedure
”PROTECTION GRILL REMOVAL - REFITTING”.
Remove the radiator assembly as described in the procedure
”RADIATOR ASSEMBLY REMOVAL - REFITTING”.
Remove the fan as described in the procedure ”FAN
REMOVAL - REFITTING”.
Figure 25
225040
Using a 1/2 inch square wrench, operate on the belt tensioner
(1) and remove the control belt of the crankshaft /
electromagnetic coupling / water pump / alternator (A)
pulley.
Figure 26
225046
Unscrew the screws (1) and remove the electromagnetic
coupling pulley assembly (2).
Ref.
No. Description
(1) 5 Nut M12 X 1.75
Figure 27
225047
Undo the bolt (1) if necessary and remove spacer (3), pulley
(2) and support (4).
Ref.
No. Description
(1) 1 Bolt M10
Refitting
Figure 28
225047
Fit the pulley (2) onto its support (4), spacer (3) and tighten
the bolt (1) to the torque indicated in the table.
Ref.
No. Description
Tightening
torques
(1) 1 Bolt M10 67.5 ± 7.5 Nm
To Next Page
Loading...
