2. Replacement and adjustment of parts
26810
3/4
26810
Zigzag adjustment
4. When the zigzagging of the magazine mount is adjusted, perform the right angle adjustment of the
cutter unit.
See ☞ The right angle adjustment of the cutter unit in 25620.
IMPORTANT
• Only when the zigzagging of all the magazine mounts is adjusted, perform the right angle adjustment of the
cutter unit.
5. Perform Arm Unit 1 Zigzagging Correction.
☞36060
IMPORTANT
• Perform arm unit 1 zigzagging correction for each paper magazine A, A2, B, and C.
• Make test prints via Test Print Confirmation 1/2 to check the zigzagging amounts (A - C) of two prints are
within the tolerance level in the following table.
If they are within the tolerance level, the adjustment is not necessary.
The center line of the first print leans to the right. The center line of the first print leans to the left.
Pattern No. Amount of
zigzagging
Inclination direction
of the center line
P1 A-C Right
P2 A+C
P3 C-A
P4 C-A Left
P5 A+C
P6 A-C
A
C
A
A
C
C
P1
P2
P3
C
A
A
A
C
C
P4
P5
P6
Distributed by: minilablaser.com
To Next Page
Loading...