2. Replacement and adjustment of parts
22100
4/8
22100
Magazine section
3. When magazine B is set on the positioning pin after the positioning pin is adjusted, check that the gap
under the magazine B is 0.5 mm.
4. If the gap under the magazine B is not 0.5 mm when the magazine B is set on the positioning pin,
loosen the screws on magazine deck B. (four screws)
5. Adjust the height of the magazine deck B so that the gap under magazine B is 0.5 mm when magazine
B is set on the positioning pin. (Two adjusting screws and two nuts)
6. Tighten screws on the magazine deck B. (four screws)
7. Perform Arm Unit 1 Zigzagging Correction.
☞36060
8. When repeating the zigzagging adjustment of magazine deck B, repeat Step 1 to Step 7.
Magazine deck B
Magazine B
G072379
Magazine deck B
Loosen these screws.
Loosen this screw.
Loosen this screw.
Adjusting screws and nuts
G072380
Distributed by: minilablaser.com
To Next Page
Loading...