5. Operation sequence
56100
4/4
56100
Processor paper advance operation
!
!!
! Paper output to the print conveyor unit
1. The paper leading edge passes through the print sensor in the dryer rack.
• The message ☞ No. 05535-00000: Paper has jammed in the processor section. is shown if any of Print Sensor
(Left), Print Sensor (Center) or Print Sensor (Right) of the dryer rack does not turn dark when paper is output to the
print conveyor unit.
• The print sensor (left, center, right) detects paper sent to the print conveyor unit.
2. The prints are output to the print conveyor unit.
• For movement of the print conveyor unit, see ☞56200.
NOTE
• A specified length of time after the print sensor detects the trailing edge of the final sheet of paper
Processor drive motor: OFF
Dryer fan: OFF
Dryer heater: OFF
Print receiving tray (large)
Dryer lane select sensor: SE45
Long Length Print Tray
Print conveyor unit
Print sensor (right): SE28
Print sensor (center): SE29
Print sensor (left): SE30
Dryer selection solenoid 1
G085228
Print sensor (left)
Print sensor (right)
Paper advance direction
1
3
2
5
4
Print sensor (center)
Dryer rack
6
7
G082007
Distributed by: minilablaser.com
To Next Page
Loading...