CHAPTER 6: ACTUAL VALUES 6.2 STATUS
GEK-106310-AF F650 DIGITAL BAY CONTROLLER 6-29
• E2PROM Status: LED associated lights in green if E2PROM is configured and working properly
• DS
P COMM ERROR: LED associated lights in green if communication error between DSP and main
processor.
• Magnetic module err
or: LED associated lights in green if communication error between DSP and magnetic
module.
• Pl
c error: PLC equations sent to the relay have an error or are incorrect.
• Ne
t conf error: Network configuration is incorrect
• Or
der code error: Order code and hardware configuration do not match
• To
tal RAM: Total RAM in the device
• Used DRAM: Used
RAM in the device
• Fr
ee RAM: Available RAM in the device
• UpT
ime: DSP heartbeat
• DS
P Counter: Percentage of CPU in use
• CPU Usag
e: Percentage of CPU in use
• IC
D Status: Information about status of ICD file stored in the F650. For detailed information go to
Chapter 7, section 7.3.2.2 IEC 61850 CONFIGURATOR FEATURES FOR CONFIGURATION
• ICD S
tatus NotVal: Information about validation of new ICD after being sent into the relay. For detailed
information go to Chapter 7, section 7.3.2.2 IEC 61850 CONFIGURATOR FEATURES FOR
CONFIGURATION
• Dsp S
tatus: Internal status of the DSP
• Flash Usage: FL
ASH memory in use
• KI
NETIS Status: Kinetis working mode
• CPU MAX
Usage: Maximum measured CPU usage
• T
emp Current Value: Current temperature of CPU. This value is displayed in Celsius units.
DSP Counter
CPU Usage
ICD Status
ICD Status NOTVAL
DSP Status
FLASH Usage
KINETICS Usage
CPU Max Usage
Temp Current Value
Temp Max Value
Temp Min Value
Scan Cycle Average
Scan Cycle Rate
PLC Checksum
Settings Checksum
MAC Address
Serial Number
Manufacturer date
To Next Page