7-228 F650 DIGITAL BAY CONTROLLER GEK-106310-AF
7.3 IEC 61850 CONFIGURATOR CHAPTER 7: IEC 61850 PROTOCOL
• Sensitive ground time overcurrent: SGhsePTOC1*/ hsePTOC1
• Sensitive ground time overcurrent: hsePTOC**
• Negative sequence time overcurrent: NgSeqPTOC**
PTOF
• Overfrequency: SGPTOF1*/ PTOF1
PTOV
• Phase overvoltage: SGphsPTOV1*/ phsPTOV1
• Auxiliary overvoltage: SGauxPTOV1*/ auxPTOV1
• Neutral overvoltage: SGneuHiPTOV1 and SG
neuLoPTOV1*/ neuHiPTOV1 and neuLoPTOV1
PTUV
• Phase undervoltage: SGphsPTUV1*/ phsPTUV1
• Auxiliary undervoltage: SG
auxPTUV1*/ auxPTUV1
PTUF
• Underfrequency: SGPTUF1*/ PTUF1
RDIR
• Phase directional element: SGphsRDIR1*/ phsRDIR1
• Neutral directional element: SGndRDIR1*/ ndRDIR1
• Ground directional element: SGgndRDIR1*/ gndRDIR1
• Sensitive ground directional element: SGhseRDIR1*/ hseRDIR1
PDOP
• Forward overpower: FwdPDOP **
• Directional overpower: DirPDOP**
• Wattmeter ground overpower: WattPDOP**
PFRC
• Frequency rate of change: PFRC**
PDIS
• Load encroachment: LodEncPDIS**
PRTR
•Locked Rotor: LockedPRTR**
*These logical nodes model the corresponding protection function for setting groups in firmware version from 7.20 to
below 7.50
**These functions have been included from firmware version 7.50.
If “Use Setting Group” is set to true for firmware version from 7.20 to below 7.50, the new instances of the Logical Nodes
are accessible with the IEC 61850 Configurator as is shown in the following figure.
To Next Page