Gemalto CINTERION BGS2T - Page 178

BGS2T AT Command Set
8.2 AT+COPS
BGS2T_ATC_V01.301 Page 178 of 554 1/31/12
c
Parameter Description
Operator Status
0 Unknown
1 Operator available
2 Current operator
3 Operator forbidden
Operator Name
If test command: Operator name in long alphanumeric format and numeric format.
If read command: Operator name as per <format>.
If write command: Operator name in numeric format.
Parameter values 0 and 1 are stored non-volatile in the BGS2T.
0
(D)
Automatic mode; <opName> field is ignored.
1 Manual operator selection
Write command requires <opName> in numeric format, i.e. <format> shall be
2.
Read command returns the current <mode> and the currently selected
<opName>. If no operator is selected, <format> and <opName> are omitted.
2 Manually deregister from network and remain unregistered until <mode>=0 or
1 or 4 is selected.
3 Set only <format> (for AT+COPS read command).
4 Automatic / manual selection; if manual selection fails, automatic mode
(<mode>=0) is entered (<opName> field will be present).
Parameter is global for all instances.
0
(&F)
Long alphanumeric format of <opName>. Can be up to 16 characters long.
2 Numeric format of <opName>. This is the GSM Location Area Identification
(LAI) number, which consists of the 3-digit Mobile Country Code (MCC) plus
the 2- or 3-digit Mobile Network Code (MNC).
Write Command
AT+COPS=<mode>[, <format>[, <opName>]]
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3  Last Reference(s)
± + + + + - - 3GPP TS 27.007 [35]
<opStatus>
(num)
<opName>
(str)(&V)
<mode>
(num)(&V)
<format>
(num)(&W)(&V)
Confidential / Released