BGS2T AT Command Set
10.1 AT^SICS
BGS2T_ATC_V01.301 Page 243 of 554 1/31/12
c
Parameter Description
0...5 Internet connection profile identifier.
The <conProfileId> identifies all parameters of a connection profile, and,
when a service profile is created with AT^SISS the <conProfileId> needs
to be set as "conId" value of the AT^SISS parameter <srvParmTag>.
Internet connection parameter.
“conType“ Type of Internet connection.
For supported values of <conParmValue> refer to <conParmValue-con-
Type>.
“alphabet“ Selects the character set for input and output of string parameters within a pro-
file.
The selected value is bound to the specific profile. This means that different
profiles may use different alphabets. Unlike other parameters the alphabet can
be changed no matter whether the <conParmTag> value "conType" has been
set.
For supported values of <conParmValue> refer to <conParmValue-
alphabet>.
“user“ User name string: maximum 31 characters (where "" is default).
“passwd“ Password string: maximum 31 characters (where ***** is default).
“apn“ Access point name string value: maximum 99 characters (where "" is default).
“inactTO“ Inactivity timeout value in seconds: 0 ... 2
16
-1, default = 20
Number of seconds the bearer remains open although the service no longer
needs the bearer connection.
Do not set the timeout value below 3 sec. This may result in problems when
using the <eodFlag> (set in the last AT^SISW command to terminate an
upload data stream).
“calledNum“ Called BCD number.
“dataType“ Data call type.
For supported values of <conParmValue> refer to <conParmValue-
dataType>.
“dns1“ Primary DNS server address (IP address in dotted-four-byte format).
This value determines whether to use the DNS server addresses dynamically
assigned by the network or a specific DNS server address given by the user.
"dns1" = "0.0.0.0" (default) means that the CSD or GPRS connection profile
uses dynamic DNS assignment. Any other address means that the Primary
DNS is manually set.
The default value applies automatically if no other address is set. Note that the
Write Command
AT^SICS=<conProfileId>, <conParmTag>, <conParmValue>
Response(s)
OK
ERROR
+CME ERROR: <err>
PIN ASC0 MUX1 MUX2 MUX3 Last
- + + + + - -
<conProfileId>
(num)
<conParmTag>
(str)
To Next Page
Loading...
Need help?
General
