BGS2T AT Command Set
16.2 AT+CPBR
BGS2T_ATC_V01.301 Page 487 of 554 1/31/12
c
Phone number in format specified by <type>, it may be an empty string.
Type of address octet, which defines the used type of number (ton) and the numbering plan identification (npi).
Please consider that for types other than 129 or 145 dialing from phonebook with ATD><mem><n> is, depending
on the network, not always possible (refer to 3GPP TS 24.008 [32] subclause 10.5.4.7 for details). See also
<type> of AT+CPBW.
Possible values are:
145 Dialing string <number> includes international access code character '+'
161 National number. Network support of this type is optional.
209 Dialing string <number> has been saved as ASCII string and includes non-
digit characters other than "*", "#", "+" or "p". Note that phonebook entries
saved with this type cannot be dialed.
255 Dialing string <number> is a command to control a Supplementary Service,
i.e. "*", "#" codes are contained. Network support of this type is optional.
129 Otherwise
Text assigned to a phone number. The maximum length for this parameter is given with test command response
parameter <tlength>.
If using an ASCII terminal characters which are coded differently in ASCII and GSM have to be entered via
escape sequences as described in Section 1.6, Supported character sets.
Maximum location number for the currently selected storage. For phonebooks located on the SIM this value
depends on the SIM card type.
Maximum length of phone number for "normal" locations. Depending on the storage a limited number of loca-
tions with extended memory is available per phonebook. These locations allow storing numbers with twice the
standard length, which is 2*<nlength> digits for normal numbers, but only <nlength> digits for numbers
saved with <type>=209.
Maximum length of <text> assigned to the telephone number. The value indicated by the test command is
given in octets. If <text> is given as GSM characters each character corresponds to one octet. If the <text>
string is given in UCS2, the maximum number of characters depends on the coding scheme used for the alpha
field of the SIM according to 3GPP TS 11.11 [14], Annex B. In the worst case the number of UCS2 characters
is at least one less than half the number of GSM characters.
Note
• Users should be aware that when using this AT command quickly after SIM PIN authentication the SIM data
may not yet be accessible, resulting in a short delay before the requested AT command response is returned.
See Section 19.1, Restricted access to SIM data after SIM PIN authentication for further detail.
<number>
(str)
<type>
(num)
<text>
(str)(+CSCS)
<maxloc>
(num)
<nlength>
(num)
<tlength>
(num)
To Next Page
Loading...
Need help?
General
