Table 119. Upgrade error codes from using the applysoftware command and recommended
actions (continued)
Error Code
The applysoftware
command explanation Action
EFSSG4101A The applysoftware command
returned required parameter
not specified.
EFSSG4102 The software package does
not exist.
Verify that the file actually
exists where specified. Also
verify that the command is
passing the correct location
parameters.
EFSSG4102A The applysoftware command
returned software package
does not exist
EFSSG4103 The software package is not
valid.
The package might be
corrupt. If this problem
persists, download a new
package and try again.
EFSSG4103A The applysoftware command
returned invalid software
package return code.
EFSSG4104 An unexpected return code. Call your next level of
support.
EFSSG4105 Unable to mount the USB
flash drive.
Run umount /media/usb, then
remove the USB flash drive.
Reinsert the USB flash drive.
If the error persists, remove
the USB flash drive and
reboot. After the system
reboots, reinsert the USB
flash drive.
EFSSG4105C The applysoftware command
returned unable to mount
USB.
EFSSG4106A The applysoftware command
returned that there is
insufficient system file
system space.
EFSSG4153 The required parameter was
not specified.
Verify that the file actually
exists where specified. Also
verify that the command is
passing the correct location
parameters.
EFSSG4154 You must start on primary
management node
mgmt001st001.
Switch to the other node and
try the command again.
EFSSG4154A The applysoftware returned
must start on primary
management node
mgmt001st001.
Chapter 7. Recovery procedures 417
To Next Page
Loading...
Need help?
General
