Table 119. Upgrade error codes from using the applysoftware command and recommended
actions (continued)
Error Code
The applysoftware
command explanation Action
EFSSG4155 Unable to mount USB flash
drive.
Back up to a USB flash drive.
Enter #
backupmanagementnode
--unmount /media/usb.
Remove the USB flash drive
and insert again. If the error
persists, remove the USB
flash drive and reboot. When
the system is running, insert
the USB flash drive again.
EFSSG4155I The applysoftware command
returned upgrade is already
running.
EFSSG4156 The specified International
Organization for
Standardization (ISO) does
not exist.
Verify that the file actually
exists where specified. Also
verify that the command is
passing the correct location
parameters.
EFSSG4156A The applysoftware command
returned the specified ISO
does not exist.
EFSSG4157 The specific upgrade
International Organization
for Standardization (ISO)
content is not valid.
The package might be
corrupt. If this problem
persists, download a new
package and try again.
EFSSG4157I The applysoftware command
returned the specific upgrade
ISO invalid content.
EFSSG4158 The specific upgrade cannot
be installed over the current
version.
Check the upgrade
documentation and verify
that the level you are coming
from is compatible with the
level you are going to. If the
upgrade level is not
compatible, download the
correct level and try again. If
the upgrade level is
compatible and the error
persists, call the IBM Support
Center.
EFSSG4158I The applysoftware command
returned the specific upgrade
cannot be installed over the
current version.
EFSSG4159 The system is in an
unhealthy state and the
upgrade cannot start.
See Chapter 3, “Getting
started troubleshooting,” on
page 47. Determine if the
system has issues.
418 Storwize V7000 Unified: Problem Determination Guide 2073-720
To Next Page
Loading...
Need help?
General
