Table 120. Upgrade error codes and recommended actions (continued)
Error
Code Explanation Action
01C2 Failed while checking for current
running asynchronous jobs.
1. Attempt to check status of lsrepl. If
this command is working restart
upgrade.
2. Contact IBM Remote Technical
Support.
01C3 Could not stop CTDB. Contact IBM Remote Technical Support.
01C4 Unable to remove callbacks Contact IBM Remote Technical Support.
01C5 Could not reinstall Lib_Utils. Contact IBM Remote Technical Support.
01C6 Failed while running
sonas_update_yum.
Contact IBM Remote Technical Support.
01C7 Unable to get list of cluster nodes. Contact IBM Remote Technical Support.
01C8 Failed while running cnrsscconfig. Contact IBM Remote Technical Support.
01C9 Unable to install CIM
configuration.
Contact IBM Remote Technical Support.
01CA Unable to get name of cluster. Contact IBM Remote Technical Support.
01CB Unable to install GPFS packages. Contact IBM Remote Technical Support.
01CC Could not install platform. Upgrade
on target system.
Contact IBM Remote Technical Support.
01CD Unable to mount GPFS file systems.
1. See “Checking the GPFS file system
mount on each file module” on page
189
2. Restart upgrade and see if this was a
transient issue.
3. Follow GPFS troubleshooting
documentation.
4. Contact IBM Remote Technical
Support.
01CE Unable to update system security.
1. Restart upgrade and see if this was a
transient issue.
2. Contact IBM Remote Technical
Support.
01CF Unable to configure node.
1. Pull both power supply cables from
subject node. Wait 10 seconds, then
plug back in. After the system
restarts, try again.
2. Contact IBM Remote Technical
Support.
01D0 Unable to disable call home. Contact IBM Remote Technical Support.
01D1 Unable to enable call home. Contact IBM Remote Technical Support.
01D2 Failed to stop GPFS.
1. Follow GPFS troubleshooting
documentation.
2. Contact IBM Remote Technical
Support.
Chapter 7. Recovery procedures 423
To Next Page
Loading...
Need help?
General
