Table 34. Error messages and actions (continued)
Error code Error message Action key
0B95 Invalid parameters. D
0B96 Failed to configure the management processes on
mgmt001st001
D then A then B
0B97 IP is invalid. D
0B98 Netmask is invalid. D
0B99 IP, gateway, and netmask are not a valid
combination.
D
0B9A There was an internal error. A
0B9B Invalid NAS private key file. F
0B9C Unable to copy the NAS private key file. F
0B9D Internal error setting permissions on NAS private
key file.
A
0B9E No NAS private key file found. Verify that the
Storwize V7000 configuration ran properly.
F
0B9F Unable to find local serial number in new nodes. B
0BA0 Unable to find node at new IP address. Check the
node cabling.
C
0BA1 Remote node is at a higher code level. E
0BA2 Management IP for node not found. D
0BA3 The disk IP was not found in VPD. D
0BA4 Unable to attach to Storwize V7000 system. Private
key files might not match.
G then F
0BA5 Unable to add Storwize V7000 system to CLI. A
0BA6 The addstoragesystem CLI command has failed. G then D
0BAC Unable to find remote serial number in newnodes. C then D then B
0BAD Remote node is at a higher code level. E
0BAE Incorrect parameters. A
0BAF Unable retrieve the node serial number. A
0BCC Unable to configure policy routing D then C then B
0BB0 Unable to open pxeboot data file. A
0BB1 Unable to update pxeboot data file for node. A
0BB2 Unable to set file permissions. A
0BB3 Unable to find node serial in pxeboot data file. A
0BB4 Node had an internal error during configuration. A
0BC6 Unable to configure system. A
0BC9 Invalid arguments passed to the script. A
0BDA Error copying update test utility to controller. G then I
0BDB Error running update test utility on controller, see
Storwize V7000 for more details.
I
0BD7 Yum is reporting a package error on a node. Try running yum
manually.
01B2 Unable to start performance collection daemon. Contact IBM Remote
Technical Support.
Chapter 3. Getting started troubleshooting 57
To Next Page
Loading...
Need help?
General
