Leibinger JET3 up - Exchange Electrode Block (SK6)

Group 8 Job Editor Page 135
JET3up Release R1.06
Proceeding:
 Press on the tab< Interfaces> (2) to select the tab.
 Press on the arrow key of the drop-down list <Encoder Settings> (3)
. The
drop-down list opens for selection.
 Now select the required interface.
 If required activate now the bounce time delay by clicking on the check box (4)
.
An activated delay is displayed by
√
in the check box.
Figure 50 Select encoder interface
Bounce time delay is switched off Bounce time delay is switched on
1 –Dialog box <Basic Settings>
3 – Drop-down list <Encoder settings>
2 –Tab < Interfaces>
4 – Check box <Bounce time delay off>
Pos.
Interface
Describtion
1.
RS422
5V / 4 Signals (A, Ā, B, B)
2.
TTL
5V TTL / 2 Signals (A, B)
3.
HTL
24V / 2 Signals (A, B)
2
1
3
4